Here is a little utility called PowerOff.dl3. By running this either from config.txt or the VSOS Shell you may turn the power off the VS1005 Development Board.
To use this program, copy PowerOff.dl3 to your VSOS system disk SYS/ directory.
As far as I have tested, it works, regardless of whether you have the USB-UART or USB cable(s) connected or not. Nevertheless, if you have a different experience, let us know in this thread.
Discussion about writing software for VS1005 and the VSOS Operating System. Also posts about VS1005-related hardware design and device drivers should be posted here.
1 post • Page 1 of 1