I've managed to get my first board running (VS1005GF). Now i wanted to make a second one (same design, same everything) and soldered it together. After a few attempts i got the software up and running. But somehow when i load the SD driver i get following message: "E'SD Ident / Card stuck".
I've read about it and saw that many suggest to implement the AMPBCONF and connect the SD LDO-Regulator to GPIO0_7. Even tough my other board didn't need this driver i've implemented it in this second board. When i reboot, i can see the LDO is getting turned off for a brief moment and then is turned on again.
But still the same error.
Here a log of the Console:
I also saw that my VS1005 is getting very hot. I've measured up to 75°C. The power-consumption (w/o SD card and everything) is about 250mA. Quite high in my opinion. You think the Chip is damaged?Hello.
VSOS 3.50 build Jul 02 2020 09:12:30
VLSI Solution Oy 2012-2017 - www.vlsi.fi
Starting the kernel..
Installed system devices:
S: SPI Flash c213, handled by FAT.
Load drivers, config 0...
Driver: SDSDMONO... E'SD Ident / Card stuck'
D: SD card in SD mode
Driver: AUIADC... Input 0x0440 Rate 48000