Hi VLSI Team,
Below are some quires regarding VS1005 schematic design:-
1.If I want to dump the initial program to VS1005G-F-Q internal flash using the USB interface (USBD+ and USBD-) what all schematic design constraints I need to provide onboard?
2.If am not using internal RTC of VS1005G-F-Q can I keep the following pins open RTCVDD, XLALO_RTC, XTALI_RTC. If not can you suggest what should be the connection?
3.If am not using the FM feature of VS1005G-F-Q I keep the following pins open AVDDRF, RF_P, RF_N. If not can you suggest what should be the connection?
4.If I am not using an SD card, LCD display, and external SPI flash what should be the level of corresponding CS pins. Should i keep it low? Please confirm?
Discussion about writing software for VS1005 and the VSOS Operating System. Also posts about VS1005-related hardware design and device drivers should be posted here.
1 post • Page 1 of 1