Can I adjust Base Enhancer while in Real-Time MIDI mode without SPI?

Writing software for systems that use VLSI Solution's devices as slave codecs to a host microcontroller.
Post Reply
Davidelvig
Senior User
Posts: 38
Joined: Mon 2015-08-24 5:25

Can I adjust Base Enhancer while in Real-Time MIDI mode without SPI?

Post by Davidelvig » Tue 2020-04-14 6:58

Can Bass Enhancer be adjusted with GPIO pins states and RESET (hardware or software)?

Can I use the SPI interface while in Real-Time MIDI more (initiated by GPIO0 and GPIO1 at startup)?

User avatar
pasi
VLSI Staff
Posts: 1713
Joined: Thu 2010-07-15 16:04

Re: Can I adjust Base Enhancer while in Real-Time MIDI mode without SPI?

Post by pasi » Tue 2020-04-14 14:03

Davidelvig wrote:
Tue 2020-04-14 6:58
Can Bass Enhancer be adjusted with GPIO pins states and RESET (hardware or software)?
Not without uploading a user application.
Davidelvig wrote:
Tue 2020-04-14 6:58
Can I use the SPI interface while in Real-Time MIDI more (initiated by GPIO0 and GPIO1 at startup)?
Yes, the SCI interface operates normally, and SDI is an alternative way to input the real-time MIDI data.
Visit https://www.facebook.com/VLSISolution VLSI Solution on Facebook

Davidelvig
Senior User
Posts: 38
Joined: Mon 2015-08-24 5:25

Re: Can I adjust Base Enhancer while in Real-Time MIDI mode without SPI?

Post by Davidelvig » Tue 2020-04-14 19:55

Thanks again!

Post Reply