hello vlsi team,
please resolve below issue !
I am trying to setup shell on my customized vs1005 board.
Discussion about writing software for VS1005 and the VSOS Operating System. Also posts about VS1005-related hardware design and device drivers should be posted here.
2 posts • Page 1 of 1
Using USB, copy the root files to the SPI flash. The root has SYS folder which has the VS1010 drivers, libraries and executables. One of these is S:SYS/GETCMD.DL3, which must be found for the shell to be able to get command line input. It's not found, so you get the error.