Using the external or internal flash on Breakout board

Discussion about writing software for VS1005 and the VSOS Operating System. Also posts about VS1005-related hardware design and device drivers should be posted here.
Post Reply
maris_n_s
User
Posts: 5
Joined: Thu 2017-01-26 13:36

Using the external or internal flash on Breakout board

Post by maris_n_s » Thu 2018-05-10 10:14

Good day
I don't understand exactly how to use external flash:
How I understand I can put my VSOS operational system and necessary *.dl3 drivers into internal chip memory, that is very small.
But how to use external flash (usb flash)
and mentioned Embedded 8Mbit Flash for placing *.dl3 drivers here?

(Also Does the special formatting procedure will be used for usb flash?)

User avatar
Panu
VLSI Staff
Posts: 2499
Joined: Tue 2010-06-22 13:43

Re: Using the external or internal flash on Breakout board

Post by Panu » Sat 2018-05-12 22:28

Hi!

You ask very basic questions. It would be good for you to watch the educational videos first, to understand the fundamentals:

viewtopic.php?f=13&t=1273#p5655

-Panu
Info: Line In and Line Out, VS1000 User interface, Overlay howto, Latest VSIDE, MCU Howto, Youtube
Panu-Kristian Poiksalo, VLSI Solution Oy

Post Reply