I purchased a STM32F407VET6(https://www.kynix.com/components/STM32F ... tures.html) (Black) board based on the recommendations of the wiki and have done a large amount of reading and trial and error.
I have been unable to get this board working with the Arduino IDE and USB (though I have had some success with the STM Discovery F4 (MB997B).
I have tried to program the STM32F407VET6 with the STlink on the STM Discovery F4 (MB997B) but have had no success with that either. I am using OSX if that makes a difference.
I would like to know if someone could tell me exactly how I can start programming the STM32F407VET6 with the Arduino IDE and USB or with the Arduino IDE and STlink?
Writing software that controls the system and peripherals such as displays, SD cards, Buttons, LEDs, Serial Ports etc.
1 post • Page 1 of 1